You are viewing as a Guest.

Welcome to skatingforums - over 10 years of figure skating discussions for skaters, coaches, judges and parents!

Please register to be able to access all features of this message board.

Author Topic: Jackson Proflex - putting leather bit back on after changing wires  (Read 650 times)

0 Members and 1 Guest are viewing this topic.

Offline katz in boots

  • Homologating Quadrubles
  • **
  • Joined: Aug 2010
  • Posts: 135
  • Total GOE: 9
(Jackson proflex boots are discontinued, this may apply only to those who have some experience with these boots)
I took the back off my boots to replace frayed wires, then glued them back on. No problems with all that, however I cannot get them to sit flat enough to the boot.
They impede the action of the boa tightening knob.  I've repeated the process a couple of times, and ended up taking them off altogether in frustration.

Anyone here done their own boa wire replacement & encountered problems, found a way to avoid this problem?